CTRL+ALT+DEL substitute in Ubuntu

CTRL+ALT+DEL substitute in Ubuntu

If anyone faces a freeze with Ubuntu where you cannot do anything, then this will certainly be helpful if you want to reboot the OS as cleanly as possible without damaging their HDD’s or losing their data.

In case of a freeze where you cannot do anything, simply press Alt+PrintScreen+R+E+I+S+U+B, keep in mind that the underlined keys must be kept pressed through the rest of the sequence AND that you will need to keep holding the sequence keys for a small period of time before going to the next one so that their actions can be carried out properly (For example, hold the R key for about 1-2 seconds before moving on to S). If the sequence does not work at first, then increase the time period between each sequence key press and try again.

It stands for Raw (take control of keyboard back from X), tErminate (send SIGTERM to all processes, allowing them to terminate gracefully), kIll (send SIGKILL to all processes, forcing them to terminate immediately), Sync (flush data to disk), Unmount (remount all filesystems read-only), reBoot. These keystrokes should be entered a few seconds apart. This should prevent a fsck being required on reboot; it also gives some programs a chance to save emergency backups of unsaved work.

Here is a breakdown of the other sysrq keys:
0 – 9 – sets the console log level, controlling which kernel messages will be printed to your console so that you don’t get flooded.

B – restarts the system without making steps to ensure that the conditions are good for a safe reboot, using this key alone is like doing a cold reboot.

E – sends SIGTERM to all processes except init. This means that an attempt is done to end the current processes except init, safely, e.g. saving a document.

F – call oom_kill(Out Of Memory Killer), which will kill a process that is consuming all available memory.

H – displays help about the SysRq keys on a terminal though in actuality you can use any key except for the ones specified, to display help.

I – sends SIGKILL to all processes except init. This means that all the processes except for init are killed, any data in processes that are killed will be lost.

K – kills all processes on the current terminal. It is a bad idea to do this on a console where X is running as the GUI will stop and you can’t see what you type, so you will need to switch to a tty after doing the magic SysRq.

L – sends SIGKILL to all processes, including init. This means that every process including init will be killed, using this key will render your system non-functional and no further magicSysRq keys can be used. So in this case you will have to cold reboot it.

M – dumps memory info to your console.

O – shuts down the system via ACPI or in older systems, APM. As in key “B”, using this key alone is like a cold reboot(Or in this case, a cold shutdown).

P – dumps the current registers and flags to your console.

Q – dumps all timers info to your console.

R – takes keyboard and mouse control from the X server. This can be useful if the X-Server crashed, you can change to a console and kill the X-Server or check the error log.

S – writes all data from the disc cache to the hard-discs, it is a sync and is necessary to reduce the chances of data corruption.

T – dumps a list of current tasks and info to your console.

U – remounts all mounted filesystems read-only. After using this key, you can reboot the system with Alt+SysRq+B without harming the system.

W – dumps uninterruptable (blocked) state tasks.

For more information see wikipedia

Leave a Reply

Your email address will not be published. Required fields are marked *